The Warn website wasn't clear if it was the right part, one page said through '19, another said through '21.It fit my '21 just fine. Instead of holding the plate up and marking the hole, I found this process much easier.Start with the rear holes by the foot peg brackets. The plastic guard on the ATV measures 14 3/4"" across. The inside of the two holes on the plate are 11 5/8"". So about 3"" difference. Measure in 1.5"" from the outside on each side of the plastic guard. Then drill the holes. The U bolt drops right through. Tighten up the nuts on both sides.Then drill holes in the plastic guard for the front U bolts through the holes that are in the plate. Much easier than trying to hold and guess where holes should go.It took me about 30 minutes to install, but would only take about 15 now that I figured out how to do it by measuring first.